DAQ Meeting/20180801

From PREX Wiki
Jump to: navigation, search

Back to Main Page >> DAQ Documentation Portal >> DAQ Meetings

previous meeting << >> following meeting

Logistic information

BlueJeans calling instructions:
Toll-Free Number (U.S.& Canada): 888-240-2560
International toll number:     408-740-7256
Bluejeans CODE:         475 839 391
Bluejeans link: https://bluejeans.com/475839391

Agenda

  • Bob and Cameron : Replace bad NIM crate with new one and ensure that original functionality is still there, including the delayed T_Settle output to the STR7200 Scaler
  • Bob and Cameron : Get Bank data structure incorporated in Prex_ts_banks.crl functionality
  • Simona and Cameron : Cameron will go through the old Moller Polarimeter DAQ and Analysis code to understand and document it on the hallaweb wiki

Minutes

  • Bob and Cameron: Replace NIM crate in Injector Parity DAQ
    • We replaced the bad NIM crate with a new one from Riad
    • We noted the wires and put everything back
    • We also restored the T_Settle delayed-to-STR7200 module
      • The delay offset is not behaving as expected when twisting knobs - Ask Paul King
    • Run 4122 is an Injector.crl run in TI-standalone triggering mode
    • Run 4123 is another - data looks good in both
    • Check if the helicity signal looks good
      • Amali's notes for checking helicity signal - some problems existed, eventually got worked out, but we need a timing diagram and we need to verify that things are working as intended later
  • Bob and Cameron: Adding in Bank structures to Prex_ts_banks.crl
    • Bob says that putting a bank around groups of similar modules is fine, rather than having a bank per individual module
    • This could get complicated for the current configuration that has some conditional flags determining which modules are read for the same old-style header
  • Simona and Cameron: Moller Polarimeter DAQ and Analysis code
    • Prex II will run wil the "old DAQ" while the "new DAQ" is being developed and deployed in parallel
    • PAW code is being used to do the analysis (compiled exec commands from .f files)
      • Roman Pomatsalyuk wrote the code
      • We should rewrite it in C++ so it can be tracked and known by newer people too
      • /adaq1/data1/moller has NTuples and CODA files stored in it
      • /moller/bin/rawread turns CODA files into NTuples
    • Roman will send a detailed DAQ map so we can check that everything is still connected - Friday at 10:30 AM
    • We will have Weekly Meetings on Tuesday mornings
    • Hall A closes in the 3rd week of September

Testing

Today's testing