|
|
| Line 1: |
Line 1: |
| − | See a summary of steps in [https://logbooks.jlab.org/entry/3634496 HALOG 3634496]. There is an expert [Tritium Wiki explanation ] of the HV GUI in general ([https://hallaweb.jlab.org/wiki/index.php/HV_HowTo_for_Experts here]).
| |
| | | | |
| − | To add HV settings configurations for proper monitoring and mapping:
| |
| − | * Log into aslow@adaq3 (using the adaq password
| |
| − | * Run the hvs [right/left] command in the ~/slowc folder
| |
| − | ** Use: Tools->Map Configurator, and then compare the voltage maps with the displayed voltages to make sure you are looking at the right ones
| |
| − | If you need to add your own configuration that isn't already one of the available maps
| |
| − | * Edit the ~/RIGHT/[whatever].map to contain the information you need (which requires that you know what HV cards your channels are plugged into, see the other maps for examples)
| |
| − | * Then do: Tools->Add/remove frame list->Cancel->Update Connections, which updates the map list
| |
| − | If the HV control GUI doesn't load, then you need to log into pi@rpi7, with Bob's rpi password, then run ./start_hv, and if that doesn't work, you will need to make sure the cron job is running in the background (./scripts/start_hv_cron) and then continue using aslow@adaq3's hvs command to proceed.
| |
| − |
| |
| − | The SAMs are in rpi7:2001 port, S4 slot, L0.0->L0.7 channels
| |
| − |
| |
| − | The SAM wired connections are established as indicated in this [[:media:SAMs_connections.pdf|PDF]] (but Actually, there is an error; SAM4 and SAM8 are connected to KDPA001 not KDPB001).
| |
| − |
| |
| − | Devi made some initial pedestal studies: see [https://ace.phys.virginia.edu:80/HAPPEX/3607 HAPLOG 3607], and more recently, see [https://ace.phys.virginia.edu:80/HAPPEX/3617 3617] and [https://ace.phys.virginia.edu:80/HAPPEX/3618 3618]
| |
| − | And SAM Pedestals are described in [https://ace.phys.virginia.edu:80/HAPPEX/3608 3608]
| |
