Difference between revisions of "BMOD 21Nov2019"
From PREX Wiki
Jump to navigationJump to search (→Agenda) |
(→Notes) |
||
| Line 21: | Line 21: | ||
==Notes== | ==Notes== | ||
*PREX | *PREX | ||
| + | ** Plot the residual correlation on the super cycle level to pin down the overestimated error bar. | ||
| + | **error flag | ||
| + | ***without error flag to see if the trim coils are running (rather than missing the trigger). | ||
| + | *** It might be the stability cut issue | ||
*CREX | *CREX | ||
| − | + | **Elegant Simulations | |
| + | **To make sure that the coil kik is same as PREX. | ||
| + | **Get the table of the slopes and centroid at target/BPMS position | ||
| + | **look at the spread of BPM12X plots at downstream target region. The dispersion between bpm11X and bpm12X is a factor of 2. | ||
== Attendence == | == Attendence == | ||
Latest revision as of 16:49, 22 November 2019
Logistic information
BlueJeans calling instructions: Toll-Free Number (U.S.& Canada): 888-240-2560 International toll number: 408-740-7256 Bluejeans CODE: 348778076 Bluejeans link: https://bluejeans.com/348778076
Agenda
- PREX re-spin
- Residual correlation check [1]
- error flag/mask issue
- run-ranged maps (for the respin)
- by Monday from Victoria
- CREX prep
- Test of the beam modulation system (with CW beam)
- Elegant Simulations Carrington Metts
Notes
- PREX
- Plot the residual correlation on the super cycle level to pin down the overestimated error bar.
- error flag
- without error flag to see if the trim coils are running (rather than missing the trigger).
- It might be the stability cut issue
- CREX
- Elegant Simulations
- To make sure that the coil kik is same as PREX.
- Get the table of the slopes and centroid at target/BPMS position
- look at the spread of BPM12X plots at downstream target region. The dispersion between bpm11X and bpm12X is a factor of 2.
