Difference between revisions of "Doing a calibration run"
From PREX Wiki
Jump to navigationJump to search (Created page with "==UNSER-type BCM Calibration == * Beam OFF (target can be out / HOME) * Start Parity DAQ run * Request MCC send 150uA - take 30sec-1min of data * Request MCC BEAM OFF - tak...") |
|||
| Line 3: | Line 3: | ||
* Beam OFF (target can be out / HOME) | * Beam OFF (target can be out / HOME) | ||
* Start Parity DAQ run | * Start Parity DAQ run | ||
| − | * Request MCC send 150uA - take 30sec-1min of data | + | ** Request MCC send 150uA - take 30sec-1min of data |
| − | * Request MCC BEAM OFF - take 30sec-1min of data with no beam (this is the UNSER pedestal) | + | ** Request MCC BEAM OFF - take 30sec-1min of data with no beam (this is the UNSER pedestal) |
| − | * | + | ** Request MCC |
Revision as of 17:03, 10 December 2019
UNSER-type BCM Calibration
- Beam OFF (target can be out / HOME)
- Start Parity DAQ run
- Request MCC send 150uA - take 30sec-1min of data
- Request MCC BEAM OFF - take 30sec-1min of data with no beam (this is the UNSER pedestal)
- Request MCC
