Target density variation check

From PREX Wiki
Revision as of 14:13, 4 September 2019 by Sanghwa (talk | contribs)
Jump to navigationJump to search
  • First measurement 09/02/2019
    • HALOG summary
    • Target #7 and #10 were checked for current range 5-70uA
    • Septum mistuned on purpose in order to reduce rates, T2 trigger is used
    • Sieve in
    • Clear non-uniformity observed from degraded target (#10) compared to good (still in use) target (#7).
    • More visible at higher current, but hint of similar signature of density rearrangement seen at low current.
    • Consistent results from both LHRS and RHRS spot data


  • Second measurement 09/03/2019
    • HALOG summary
    • Took high statistics run at very low current (30nA requested), Target #10
    • Septum at nominal setting, no Sieve
    • Similar result shown in RHRS data as previous high current test
    • Different distribution in LHRS is puzzling, might be related to DAQ problem


  • Qsq runs 09/03/2019
    • 400-500k events for LHRS and RHRS runs during Qsq measurements with various targets (Pb7, 8, 9, 10)
    • HALOG run summary
    • Consistency between LHRS and RHRS recovered for target #10 [1]
Retrieved from "https://prex.jlab.org/wiki/index.php?title=Target_density_variation_check&oldid=8692"