InsertingTargetProcedure

1. Measure the raster size with the 90-degree carbon hole
   1. With no target, establish 5 uA beam. Move beam center to center on carbon hole location
   2. turn off beam. Move in C-hole 90deg target.
   3. turn on 20 nanoAmp beam. Set raster to current units.
   4. run spot++. verify that raster (4mm x 6mm in reality) is (approximately) appropriately filled by the 2mm diameter hole.
   5. remove the C-hole target
2. Prepare beam for Lead target
   1. establish 1 uA beam (with no target)
   2. move beam to collimator center 4A(x,y) = (0,0) and 4E(x,y) = (0.6, 0.4)mm.
   3. set raster to 10x10
   4. set current to 20 nanoAmps
   5. verify that VDC and GEM detector HV are off
3. Move to lead target
   1. mask and insert lead target
   2. establish 20nanoAmp beam.
   3. run spot++. Verify no edges.
   4. Set raster to nominal 6mm (width) x 7.2 mm (height)
   5. run spot++ (uniformity check)
   6. turn off S0 voltages on left and right arms.
   7. set to desired current. No more than 50uA.
      • WATCH target temperatures, target return coolant temperature, collimator temperature, and beamline thermocouples.