Flipper

• Flip IHWP state
  • to flip IHWP state, will have to inform other halls of intention to flip state first. Then call MCC and ask them to flip state.
  • Note: After the IHWP state has been changed, the parity alarms will go off until the voltages are set correctly.
  • Then (after IHWP is in new desired state), on apar@adaq2, in ~/feedback2019, run ./FlipPCValues to set the voltages correctly
  • Double check voltages are correct: on apar@adaq2, in /feedback2019, run ./checkPCvalues The output should tell you the voltages are good, otherwise call an expert.
  • if alarms go off and values don't match those in table, call an Expert
  • Update the slug number and IHWP state of the white board, write down the time of flip and first run number for new slug.

Check the values against the table in Parity Checks

special note for slug 24,25