WAC Notes July 28 2019
From PREX Wiki
Revision as of 15:42, 4 August 2019 by Adhidevi (talk | contribs) (→Non-Production Runs and Bad Runs)
| Documentation |
| HOW TOs for shift crew |
| Expert Tools |
| All Expert Contacts |
PREX Main << Weekly Analysis Coordinator << WAC Notes << Instructions
WAC Notes July 27 2019 << >> WAC Notes July 29 2019
July 28 2019
Daily Meeting BlueJeans
Production Run List
- Since we are using bcm_dg_ds, the width in the bcm asymmetry is 2X of what we had with bcm_an_ds
- Should we think about changing saturation limit for this SAM?
- If we compare with 70uA good run from previous slug, yield of SAMs on Right Hand Side has increased while on the other side decreased
Start Slug 18, IHWP IN, FFB on always
- Good - run3692
- Good - run3693
- LQ1 tripped during the mini-run 0 and mini-run 1
- Applied bad_evt_cut->Now Good
- Good - run3694
- Good - run3698
- User had marked it as Parity Scan. It is in fact a good production run
- Good - run3699
- Good - run3702
- LQ1 tripped during 0th and 1st mini-runs
- bad_evt_cut fixed it
- Good - run3703
- Short run
- Good - run3709
- Good - run3710
- Good - run3711
Non-Production Runs and Bad Runs
- Test - run3700
- Double peak test
- Large Aq mean
- Test - run3704
- Junk - run3705
- Bad - run3706
- MOLLER quad problem -> changed raster size
- Bad - run3707
- MOLLER quad problem -> changed raster size
- Bad - run3708
- LQ1 tripped during the end, applied bad_evt_cut, now good
Pedestal/Calibrations Updates
- Parity Scan - run3696
- RHWP=500
- Parity Scan - run3697
- RHWP=500, RTP cell OFF
- Parity Scan - run3695
- Parity Scan - run3701
Issues
- Prompt analysis went too slow during swing and owl shift
