20180612-Radiation-Mtg

From PREX Wiki
Revision as of 11:53, 12 June 2018 by Ciprian Gal (talk | contribs)
Jump to navigationJump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

Back to Main Page >> Radiation_Mtg

previous meeting << >> following meeting


Logistic information

 BlueJeans calling instructions:
   Toll-Free Number (U.S.&  Canada):  888-240-2560
   International toll number:         408-740-7256
   PARTICIPANT CODE:                  https://bluejeans.com/190761523


Agenda / Minutes

  1. SAM sims: Radial Scan with PREX beamline File:20180612-Radiation-Mtg-TaoYe.pdf
    • CC: Pulling out by 6cm and thinning materials gets close to radiation goals - spherical end cap simulation results coming later today
    • KP: you should include positrons for the rate for both simulations.
    • KP: can you translate that number into a width? TY: will work on it.
    • DA: how low is the electronics noise on the SAMs to make use of the 4 THz rate?
    • DA: we should pay attention to the raster (correlation between position and angle)
  2. TOSCA sims: Adam haplog3513
    • AZ: shielding that was installed for tritium was implemented in TOSCA (based on original model from Jay)
    • AZ: we were mostly concerned what happens when one quad is off
    • AZ: with no shielding the focusing is consistent with previous TOSCA models.
    • AZ: with shielding the deflection is is 0.2 cm compared to 2 cm without over 17 m.
    • KP: maybe redo starting with \pm 3 cm and do CREX beam with CREX field and PREX beam with PREX field. AZ: will have to talk to Jay about the field strength.
    • AZ: working on setup shielding, but still figuring out how Jay made the model.

Attendance

Kent P, Ciprian G, Victoria O, Adam Z, Cameron C, Tao Y, David A,

Excused: