DAQ Meeting/20180801

Back to Main Page >> DAQ Documentation Portal >> DAQ Meetings

previous meeting << >> following meeting

Logistic information

BlueJeans calling instructions:
Toll-Free Number (U.S.& Canada): 888-240-2560
International toll number:     408-740-7256
Bluejeans CODE:         475 839 391
Bluejeans link: https://bluejeans.com/475839391

Agenda

• Bob and Cameron : Replace bad NIM crate with new one and ensure that original functionality is still there, including the delayed T_Settle output to the STR7200 Scaler
• Bob and Cameron : Get Bank data structure incorporated in Prex_ts_banks.crl functionality

Minutes

• Bob and Cameron: Replace NIM crate in Injector Parity DAQ
  • We replaced the bad NIM crate with a new one from Riad
  • We noted the wires and put everything back
  • We also restored the T_Settle delayed-to-STR7200 module
    • The delay offset is not behaving as expected when twisting knobs - Ask Paul King
  • Run 4122 is an Injector.crl run in TI-standalone triggering mode
  • Run 4123 is another - data looks good in both
  • Check if the helicity signal looks good
    • Amali's notes for checking helicity signal -

• Bob and Cameron: Adding in Bank structures to Prex_ts_banks.crl
  • Bob says that putting a bank around groups of similar modules is fine, rather than having a bank per individual module
  • This could get complicated for the current configuration that has some conditional flags determining which modules are read for the same old-style header

Testing

Today's testing