Flipper

• Flip IHWP state
  • to flip IHWP state, will have to inform other halls of intention to flip state first. Then call MCC and ask them to flip state.
  • Note: After the IHWP state has been changed, the parity alarms will go off until the voltages are set correctly.
  • Then (after IHWP is in new desired state), on apar@adaq2, in ~/feedback2019, run ./FlipPCValues to set the voltages correctly
  • Double check voltages are correct: on apar@adaq2, in /feedback2019, run ./checkPCvalues The output should tell you the voltages are good, otherwise call an expert.
  • if alarms go off and values don't match those in table, call an Expert
  • Update the slug number and IHWP state of the white board, write down the time of flip and first run number for new slug.
  • Check the values against the table in Parity Checks

Special note for slugs 24,25

• For slug 24 and 25 on 8/1/2019, use ./CancelPCValues and ./checkCancelPCValues
  • to flip IHWP state, will have to inform other halls of intention to flip state first. Then call MCC and ask them to flip state.
  • Note: After the IHWP state has been changed, the parity alarms will go off until the voltages are set correctly.
  • Then (after IHWP is in new desired state), on apar@adaq2, in ~/feedback2019/CancelFlip, run ./CancelPCValues to set the voltages correctly
  • Double check voltages are correct: on apar@adaq2, in /feedback2019/CancelFlip, run ./checkCancelPCvalues The output should tell you the voltages are good, otherwise call an expert.
  • Update the slug number and IHWP state of the white board, write down the time of flip and first run number for new slug.
  • Double check AposV which has been modified: Parity Alarm for AposV will still be going off. It is OK to silence it ONLY for these slugs as long as for IHWPin, AposV=15 and for IWHPout, AposV=-237.