User talk:Jixie Zhang
Why is this titled "User talk: Jixie Zhang". In fact it is an AUXILIARY MEASUREMENT RUN PLAN from Prex-I.
PREx TODO List:
The following tables show the auxiliary measurements for the remainder of
This will be discussed at the June 11 (Friday) 3 pm meeting -- both the list of plans and the priorities.
The plans belong to 3 categories of priority:
- Plans we MUST perform.
- Plans we'd LIKE to perform, but lower priority.
- Plans we MAYBE want to do (very low priority).
|Blinded Tube Test||done||D. McNulty, K. Kumar, J. Wexler|
|Further Current Calibrations with PREx Det||2 hours||Z. Ahmed|
|Transverse Polarization Measurements.||done||Setup by J. Grames.|
|High Statistics Lead Inelastics||done||A. Camsonne|
|Oversampling by 2 at 120 Hz||few days||setup by experts|
|Q2 with GEMs||done||A. Camsonne, M.Friends|
|Backgrounds: Dipole Scan, up and down||6 hours, Finish left arm,
right arm measurement is pending
|M. Dalton, Mindy|
|Beam-Induced Linearity Studies||2 hours||K. Kumar, K. Paschke, R. Silwal|
|Further 10 nA Cavity Monitor Tests||4 hours||Z. Ahmed, R. Michaels|
|calibration of the
cavities with the amplifier
|More Moller Commissioning||12 hours||Moller crew (note Sasha is leaving town)|
Commnets: KK suggested putting "Transverse running" into "must do" and "beam induced linearity studies" into "like to do".
Bob edited the above table per KK's request
By Joe Grames: Hi Bob,
Wrt "Transverse Polarization Running" the spin rotator knobs of the INJTWF make this now rather simple. If your tolerance is <5 deg of vertical this can be done without Mott measurements and setup time is <30 minutes. If your tolerance is <2 degrees then Mott measurements are required and setup time is <2 hours. Backout of either to the original condition is likely <30 minutes.
Most importantly give the PD some advance warning.