Daily Meetings

Back to Main Page

Logistic information

 Time: Daily at 3:30pm
 Location:   Counting house conference room
 

 BlueJeans calling instructions:
 Toll-Free Number (U.S.&  Canada):  888-240-2560
 International toll number:         408-740-7256
 Bluejeans CODE:                    256 205 934 
 Bluejeans link: https://bluejeans.com/256205934

Standing Agenda

1. RC Status Report
2. Subsystem status reports
   • Integrating DAQ
   • Counting DAQ
   • Main detectors
   • SAMs
   • AT
   • PQB
   • Beam Monitors
   • Dithering
   • Target
   • WAC
   • Compton
   • Shifts
     • Shift schedule
     • Analysis shifts
   • Other
3. Daily Run Plan

ToDo:

Short term (today): Day/swing-Moller lock, optics check, adiabatic damping, (ffb?), Swing/owl-Find chole and make sure same position as before, sieve in Ca48 run, detector alignment check, Q2. Stop by 6:30am.

Longer term plan: Accelerator Tasks: Group 1:

 1. Moller lock

2. Vwein/solenoid adjustment for vertical transverse

 3. Spin Dance

4. VWein/solenoid fine tune optimization to minimize v. transverse for both flip right and flip left at new HWein angle.

Group 2:

 1. Damping test, Matching improvement
 2. Tune beam for low backgrounds through the Compton chicane
 3. FFB commissioning

Group 3:

 1. Spot size
 2. Phase Advance

———————————————— Hall Tasks: Restarting in hall:

- check target position and raster size using spot++ and carbon hole - we should start with counting run using VDCs and downstream detectors (careful setup/backout, but no access required) - remember safeguards

    o ramp rate <10uA/sec (in small steps or slower if necessary)
    o run at collimator center, but verify target is where we expect (or else, framehunt to be certain)
    o keep an eye of dp / Teifenbach measurement

Soon we need: ———————————————— - pulsed beam synch check - low current -> high current cavities - Sieve IN Ca-48 counting run (to hunt inelastic cross-sections) -recheck of det alignment -another Q2 measurement